Sony DSR-DR1000A Operating Instructions Manual page 99

SC: ±180°
* Adjust with menu settings.
** Adjust with controls on the front panel.
Audio performance
Frequency response
Two-channel (48 kHz) mode:
20 Hz to 20 kHz ±1.0 dB
Four-channel (32 kHz) mode:
20 Hz to 14.5 kHz ±1.0 dB
Dynamic range More than 87 dB
Distortion (THD + N)
Less than 0.07% (48 kHz)
Input connectors
Digital signal inputs
SDI IN BNC type
SDI format (270 Mbps), SMPTE 259M/
CCIR656-III
AUDIO (AES/EBU) IN
BNC type (×2), complying with AES-
3id-1995
S400(i.LINK) 6-pin, complied with IEEE 1394
Analog video inputs
REF. VIDEO IN
BNC type (×2, loop-through with 75 Ω
automatic terminator)
Black burst
0.286 V (DSR-DR1000A) or 0.3 V
(DSR-DR1000AP), 75 Ω, negative
sync
Composite sync
VIDEO IN BNC type (×3 and 1 loop-through
connector with 75 Ω automatic
terminator), composite/component/S-
video switchable
Composite Y/CPST and 1 loop-through connector
with 75 Ω automatic terminator: 1.0
Vp-p, 75 Ω, sync negative
Y/CPST: 1.0 Vp-p, 75 Ω, negative sync
Component
R−Y/S−C and B−Y/S−Y: 0.7 Vp-p (75%
color bars for DSR-DR1000A or 100%
color bars for DSR-DR1000AP), 75 Ω
Y/CPST: 1.0 Vp-p, 75 Ω, negative sync
S-video
R−Y/S−C: 0.286 Vp-p (DSR-DR1000A)
or 0.3 Vp-p (DSR-DR1000AP), 75 Ω
(burst level)
Analog audio inputs
AUDIO IN XLR 3-pin, female (×2), +4/0/−3*/−6
dBm, high impedance, balanced
* For DSR-DR1000A only
Time code input
TIME CODE IN
BNC type, SMPTE time code (DSR-
DR1000A) or EBU time code (DSR-
DR1000AP), 0.5 Vp-p to 18 Vp-p, 3.3
kΩ, unbalanced
Network
100BASE-TX/10BASE-T
RJ-45 type
100BASE-TX: complied with IEEE
802.3u
10BASE-T: complied with IEEE 802.3
Output connectors
Digital signal outputs
SDI OUT BNC type (×2)
SDI format (270 Mbps), SMPTE 259M/
CCIR656-III
AUDIO (AES/EBU) OUT
BNC type (×2), complying with AES-
3id-1995
S400(i.LINK) 6-pin, complied with IEEE 1394
Analog video outputs
VIDEO OUT BNC type (×3), composite/component/
S-video switchable
Y/CPST, and SUPER: 1.0 Vp-p, 75 Ω,
Composite
sync negative
Y/CPST: 1.0 Vp-p, 75 Ω, negative sync
Component
R−Y/S−C and B−Y/S−Y: 0.7 Vp-p (75%
color bars for DSR-DR1000A or 100%
color bars for DSR-DR1000AP), 75 Ω
B−Y/S−Y: 1.0 Vp-p, 75 Ω, negative sync
S-video
R−Y/S−C: 0.286 Vp-p (DSR-DR1000A)
or 0.3 Vp-p (DSR-DR1000AP), 75 Ω
(burst level)
Analog audio outputs
AUDIO OUT XLR 3-pin, male (×2), +4/0/−3*/−6 dBm,
600 Ω loading, low impedance,
balanced
Phono jack, −11
MONITOR
DR1000A)/−9
DR1000AP) ±1 dB, 47 kΩ,
unbalanced, −20 dBFS (DSR-
DR1000A)/−18 dBFS (DSR-1000AP)
* For DSR-DR1000AP only
** With the PHONES control knob at the center position
∗∗
dBu (DSR-
∗∗
dBu (DSR-
99
Specifications