Connecting A Vcr Or Similar Device; Connecting To The Line 1/Decoder Jack - Sony AT100 Operating Instructions Manual

Connecting a VCR or Similar Device

After disconnecting the recorder's mains lead from the mains, connect a VCR or similar
recording device to the LINE IN jacks of this recorder.
To watch the connected VCR or a similar device's picture through the recorder while the
recorder is in standby mode, set "Standby Mode" to "Mode 2" in the "Basic" setup
(page 118). If not, the picture will not appear.
Use the DV IN jack on the front panel if the equipment has a DV output jack (i.LINK jack)
(page 91).
For details, refer to the instruction manual supplied with the connected equipment.
To record on this recorder, see "Recording from Connected Equipment" on page 63.

Connecting to the LINE 1/DECODER jack

Connect a VCR or similar recording device to the LINE 1/DECODER jack of this recorder.
to i LINE 1/DECODER
b
Notes
• Pictures containing copy protection signals that prohibit any copying cannot be recorded.
• If you pass the recorder signals through a VCR, you may not receive a clear image on your TV screen.
DVD recorder
Be sure to connect your VCR to the DVD recorder and to your TV in the order shown below. To watch
video tapes, watch the tapes through a second line input on your TV.
VCR
• The SMARTLINK features are not available for devices connected via the DVD recorder's LINE 1/
DECODER jack.
• When you record to a VCR from this DVD recorder, do not switch the input source to TV by pressing
the TV/DVD button on the remote.
• If you disconnect the recorder's mains lead, you will not be able to view the signals from the connected
VCR.
VCR
SCART cord (not supplied)
DVD recorder
to T LINE 3 – TV
VCR
TV
to SCART input
DVD recorder
TV
Line input 1
TV
Line input 2
,continued
29