System Setting Mode Set Up; Display's Setting - Panasonic TY-FB8TA Operating Instructions Manual

SYSTEM SETTING MODE Set up

Note:
Be sure to perform this setting when PWD 8 series (TH-37PWD8WK/S, TH-42PWD8WK/S) is connected with this
terminal board. If not, no setting is required.
Press the buttons to enter the SYSTEM SETTING MODE within 1
second in accordance with the order below.
Programme Number Selection UP
Programme Number
press and hold for 3 seconds).
USE SLOT3:
Select "YES" when SLOT3 is used, if not, select "NO". Turn the unit
Off and On again to enable the new settings.
YES/NO
Note:
Without the correct settings, input switch may malfunction.
When use Slot 3
Set the value "YES".
When not in use Slot 3
Set the value "NO" (default setting).
Notes:
• Be sure to set the value "NO" while TH-37PWD8WK/S is used.
• No setting is required while PS/H9 series is used.

Display's setting

Use the display's remote controller and set the "Serial Slot Select" item in the Options menu to "Slot2".
Note: No setting is required when using the TH-37PWD8WK/S or the TH-42PWD8WK/S.
[Options menu operation method]
Press the [SET UP] button to display the "Setup" menu.
Press the [▲/▼] buttons to select "OSD Language".
Press and hold the [SURROUND] button for 3 seconds or longer to display
the "Options" menu.
Press the [▲/▼] buttons to select "Serial Slot Select".
Press the [◄/►] buttons to set "Slot2".
Press the [SET UP] button to end the setting.
, DOWN
, , , buttons (as for
buttons, Direct
button,
Example display
SYSTEM SETTING MODE
USE SLOT3 YES
SYSTEM SETTING MODE
USE SLOT3 NO
Options
Slot power Off
V. lnstallation Off
Rotate
Off
Serial Slot Select Slot2
3/3
21