Running The Qt-Based Gui Application Demonstration - Xilinx Zynq-7000 Getting Started Manual

Chapter 3: Getting Started with the Base Targeted Reference Design
If the evaluation kit design files were downloaded online, copy all the files within the
Note:
rdf0286-zc702-zvik-base-trd-2013.3/ready_to_test folder directly onto the
primary partition of the SD MMC card (which is formatted as FAT32) at the root level using an
SD MMC card reader. The files in the SD MMC card should match the list described in
SD MMC flash card containing TRD binaries formatted with FAT32, page
4. Make sure the switches are set as shown in
boot from the
X-Ref Target - Figure 3-4
Figure 3-4: Switch Settings for the Mode Switch to Boot from the SD MMC Card
5. Make sure the display monitor is set for HDMI or DVI 1920 x 1080.
Running the Qt-Based GUI Application
Demonstration
1. Power on the ZC702 board. The default binary Linux device tree configures and runs the
video demonstration for 1080p video-out resolution.
2. Start the installed UART terminal program on your host PC (e.g., Tera Term Pro on a
Windows PC, GtkTerm on a Linux PC).
Use the following UART configuration: Baud rate = 115200, bits = 8, parity = none, and
stop bits = 1.
This step is required to view debug information or to run the UART Menu-Based
Note:
Demonstration application.
32
card.
SD MMC
www.xilinx.com
Figure 3-4, which allows the ZC702 board to
ZC702 and ZVIK Getting Started Guide
UG926 (v6.0) December 17, 2013
28.
UG926_c3_04_111012
Send Feedback