Connect / Disconnect Ids; Cid; Dtmf Signaling; Stun - Kenwood TK-7180 Instruction Manual

C / D
ONNECT ISCONNECT
TK-7180/ TK-8180 Models: To transmit connect/ disconnect IDs, you must use an optional
microphone with a DTMF keypad.
1 Press the key programmed as Autodial.
• The first entry in the Autodial list appears on the display.
2 Connect ID: Press the DTMF
Disconnect ID: Press the DTMF
3 Press the microphone PTT switch to make the call.
DTMF S
IGNALING
DTMF Signaling is either enabled or disabled by your dealer. This function opens
the squelch only when the transceiver receives the DTMF code programmed in
your transceiver. Each transceiver is normally programmed with a unique code.
You will not hear calls from transceivers that are not programmed with a matching
code.
When you receive a signal containing the correct tones, squelch opens and you
will hear the call.
• The LED indicator flashes orange.
• To mute the speaker after squelch opens, press the key programmed as Monitor.
• Your dealer can program the squelch to close again after a specific time period elapses.
• If Transpond for DTMF Signaling is programmed, an acknowledgment signal is returned
to the calling station.
• If Tone Alert for DTMF Signaling is programmed, an alert tone will sound when the
correct tones are received.
S
TUN
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, either transmit mode will be disabled or
both receive mode and transmit mode will be disabled. Stun is cancelled when
the transceiver receives a call with a revive code.
ID
S
key two times.
key followed by the DTMF # key.
19