Commands Unavailable In Jitter Mode - Agilent Technologies Infiniium DCA Programmer's Manual

Introduction

Commands Unavailable in Jitter Mode

AMPLitude:LEVel:DEFine 18-7
AMPLitude:LOCation 18-7
AMPLitude:OLEVel? 18-7
AMPLitude:PI? 18-8
AMPLitude:PIRMs? 18-8
AMPLitude:Q? 18-8
AMPLitude:RINoise? 18-8
AMPLitude:RINoise:DEF 18-9
AMPLitude:RINoise:UNITs 18-9
AMPLitude:RN? 18-9
AMPLitude:RNSTabilize 18-9
AMPLitude:RNSValue 18-10
AMPLitude:SAMPlitude? 18-10
AMPLitude:TI:DEFine 18-10
AMPLitude:TI? 18-10
AMPLitude:UNITs 18-11
AMPLitude:ZLEVel? 18-11
DEFine 18-19
JITTer:DDJVsbit:BITS? 18-28
OMAMplitude 18-35
SINTegrity:BERFloor? 18-41
SINTegrity:BERLimit? 18-41
SINTegrity
The following new commands are recommended replacements for the commands
that are shown in parenthesis.
SINTegrity:PATTern? 18-41 (JITTer:PATTern? 18-31)
SINTegrity:SIGNal 18-42 (JITTer:SIGNal 18-33)
SINTegrity:SIGNal:AUTodetect 18-42 (JITTer:SIGNal:AUTodetect 18-33)
Commands Unavailable in Jitter Mode
This section describes the commands that can generate errors when controlling the instru-
ment in Jitter mode. This can be due to the command or one of its arguments that are not
allowed in Jitter mode. Refer to the individual command reference for detailed information.
1-43