Introduction
New and Revised Commands
New and Revised Commands
This section lists all new and revised commands for the 86100C software revision A.7.00.
Most of the following commands require that Jitter Mode be enabled. Each command listed is
followed by the page number where the command is documented.
Common
*OPC (Operation Complete) 3-6
Commands
Disk Commands
BFILe? 10-2
TFILe? 10-10
Display
The following new DISPlay subsystem commands are recommended replacements for the
Commands
commands shown in parenthesis.
SINTegrity:BATHtub:YSCale 11-9 (JITTer:BATHtub:YSCale 11-4)
SINTegrity:GRAPh 11-9 (JITTer:GRAPh 11-4)
SINTegrity:HISTogram:YSCale 11-9 (JITTer:HISTogram:YSCale 11-4)
SINTegrity:LAYout 11-10 (JITTer:LAYout 11-5)
SINTegrity:LEVel 11-10
SINTegrity:SHADe 11-10 (JITTer:SHADe 11-6)
Limit Test
The following new LTESt subsystem command is recommended replacements for the com-
Commands
mand shown in parenthesis.
SINTegrity:SELect 15-4 (JITTer:SELect 15-2)
Mask Test
COUNt:FAILures? 17-4
Commands
Measure
AMPLitude:ANALysis 18-4
Commands
AMPLitude:DI? 18-5
AMPLitude:EOPening? 18-5
AMPLitude:ISI? 18-5
AMPLitude:ISIVsbit? 18-5
AMPLitude:ISIVsbit:BITS? 18-6
AMPLitude:ISIVsbit:HIGHest? 18-6
AMPLitude:ISIVsbit:LOWest? 18-6
AMPLitude:LEVel:CIDigits:LEADing 18-7
AMPLitude:LEVel:CIDigits:LAGGing 18-6
1-42
(revised to work with PWAVeform:SAVE 10-6)