Table of Contents
Advertisement
RA8000 and ESA12000 Storage Subsystems
2.4
Installing Additional Components (Options)
The following sections describe the procedures for installing additional components into
the ESA12000 data center cabinet. The options available for the ESA12000 subsystem are
as follows:
•
BA370 Universal Mounting Kit (DS-BA370-XB) – Provides the components needed
to add an expansion enclosure to increase the storage capacity of your subsystem
installation. One or two BA370 enclosures can be installed in a cabinet
•
UltraSCSI Hub Shelf Mounting Kit (BA35X-RK) – Provides components to mount
a BA356 shelf into the cabinet. The hubs are installed in the BA356
•
External Cache Battery (ECB) Mounting Kit (DS-SW4XU-2U) – Provides a mid-
cabinet mounting shelf to support one or two ECB SBBs for the controller cache
modules
•
Fibre Channel (FC) Hub Mounting Kit – Installs mounting brackets to support the
FC 12-port hub
•
Filler Panel Mounting Kit (DS-SW41U-XK) – Contains blank panels to fill empty
slots in the ESA12000 cabinet
2.4.1 Installing BA370 Universal Mounting Kit DS-BA370-XB
You may wish to install one or two BA370 rack-mountable enclosures into your SW41U
or SW600 cabinet to expand the storage capacity of your subsystem. The BA370
expansion enclosure is shipped with a universal mounting kit (DS-BA370-XB) which
contains the necessary components and hardware to install the BA370 into an 41U
RETMA cabinet or an SW600 metric cabinet.
Since the BA370 enclosure universal mounting kit is
designed for use in more than one cabinet, there will be
parts left over upon completing the installation process. For
easy identification, a component part number is stamped on
each bracket.
The cabinet opening required to install a BA370 expansion
enclosure must be at least 30.5 in. (774.7 mm) high and 19
in. (482.6 mm) wide.
2–12
NOTES
387404–001
EK–SMCPR–UG. A01
Advertisement
Table of Contents
