Mains Connection; Dust Connection - Jet JWBS-10 Operating Instructions Manual

Checking the table for flatness
A steel rule should be held on the table across the table slot
close to the front edge of the table. (See Fig. 14)
If the straight edge shows there is a step across the table
slot then the table needs to be adjusted using the two
screws and locking nuts provided for this purpose, located
on the underside of the rip fence guide, at (D, Fig 14)
Lower blade guard
When open the lower bandwheel door on this machine the
lower blade guard (Fig 15).
Fig. 13
Fig. 14
The bandwheel doors MUST be closed at all times when
the machine is being operated.

5.2 Mains connection

Mains connection and any extension cords used must
comply with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a 10 A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may
only be carried out by qualified electricians.

5.3 Dust connection

The machine is equipped with a dust port dia 100mm (B,
Fig. 16).The dust port is located at the back of the band saw
for mounting a hose (not provided) to connect a dust
collector or shop vacuum.
Fig 15
Fig. 16