Disc Playback - Sony 4-165-489-11(1) Operating Instructions Manual

Symptom
Playback picture becomes
distorted.
Sound
Symptom
There is no sound.
There is no sound when the
component (digital satellite
receiver, PlayStation 3, etc.) is
connected directly to your TV
via HDMI.
Severe hum or noise is heard.
The sound loses stereo effect
when you play a VIDEO CD, a
CD, or an audio file.
There is no sound or the volume
level is very low from a certain
speaker or all the speakers.
The sound comes from the center
speaker only.
There is no system sound from
your TV.
The sound of files played from a
DATA CD/DATA DVD/USB
device is distorted.
There is noise or the sound skips
while playing a USB device.

Disc playback

Symptom
A disc does not play.
The language for the sound track
or subtitle cannot be changed.
A disc does not start playing
from the beginning.
A DATA CD/DATA DVD
cannot be played.
Problems and solutions
• Set [YC C ] in [YC C /RGB (HDMI)] to [RGB] (page 58).
B R
B R
Problems and solutions
• The speaker cord is not connected securely.
• Check the speaker settings (page 60).
• Check the following status.
– Connect the system and TV with a SCART (EURO AV) cable (page 26) and
select the "TV" function.
– Disable your TV's speakers.
• Move your TV away from the audio components.
• Clean the disc.
• Select stereo sound by pressing AUDIO (page 36).
• Check the surround setting (page 46).
• Check the speaker connections and settings (pages 25, 60).
• Depending on the DVD, the output signal may not be the entire 5.1 channel.
• A 2 channel source is being played.
• Depending on the disc, the sound may come from the center speaker only.
• Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 58).
• The HDMI OUT jack does not output Super Audio CD sound.
• Perform the following procedure.
1 Turn the system off and on again.
2 Turn the connected component off and on again.
3 Disconnect and then connect the HDMI cable again.
• The bit rate used when encoding the audio files was low. Transfer audio files
encoded with higher bit rates onto the DATA CD/DATA DVD/USB device.
• Copy the files to your computer, format the USB device in FAT12, FAT16, or
FAT32 format, and transfer the files to the USB device again.
Problems and solutions
• The region code on the DVD does not match the system.
• Moisture has condensed inside the unit and may cause damage to the lenses.
Remove the disc and leave the unit turned on for about half an hour.
• Set the language via the disc's menu.
• While in stop mode, press x on the unit or the remote and then start playback
(page 34).
• The DATA CD is not recorded in ISO 9660 Level 1/Level 2, or Joliet.
• The DATA DVD is not recorded in UDF (Universal Disk Format).
65
GB