Streaming Tab; Unicast Streaming; Video Port Number; Multicast Streaming - Sony IPELA SNC-RX550N User Manual

Bandwidth control (for JPEG only)
Limits the network bandwidth for the JPEG image data
output from the camera. Selectable bandwidths are as
follows:
0.5, 0.6, 0.7, 0.8, 0.9, 1.0, 2.0, 3.0, 4.0 (Mbps), and
Unlimited
Note
Audio may be interrupted depending on the selected
bandwidth. In that case, select a wider bandwidth.
Bit rate (for MPEG4 only)
Set the bit rate of MPEG4 image transmission for a line.
Selectable values are as follows:
64, 128, 256, 384, 512, 768, 1024, 1536, 2048 (kbps)
Notes
• The actual frame rate and bit rate may be different
according to the image size, the shooting scene, or the
network condition.
• When MPEG4 is selected, the image size is set to 640
× 480 (VGA) and the frame rate is set to 30 fps.
The frame rate may be decreased when the bit rate is
more than 512 kbps or while the object detection
function is operating.
• When the camera operation mode is set to Dual codec
and the image size is set to 640 × 480 (VGA) in
MPEG4 setting, the maximum frame rate at which
the camera can transmit data will be 20 fps.
• When the camera operation mode is set to Dual codec,
the actual values set in MPEG4 setting and JPEG
setting may not be obtained, due to the limitation in
the capacity to manage two video codecs
simultaneously. Use the following table as a guide for
the settings.
Capacity to manage two video codecs
simultaneously
JPEG
SNC- SNC-
RX550N RX550P
VGA 15 fps 12 fps
fps
VGA 20 16
fps
VGA 10 8
fps
VGA 15 12
QVGA 30 fps 25 fps
OK/Cancel
See "Buttons common to every menu" on page 30.
40
Setting the Camera Image and Audio — Camera Menu
MPEG4
SNC- SNC-
RX550N RX550P
fps
VGA 15 12 fps
fps fps
VGA 10 8
fps fps
QVGA 30 25
fps fps
QVGA 20 16
QVGA 30 fps 25 fps

Streaming Tab

Use this tab to set the items for the transmission by UDP
or multicast.

Unicast streaming

Specify the transmission port numbers of the video data
and audio data to be used when UDP (Unicast) is
selected with

Video port number

Specify the transmission port number of the MPEG4
video data. It is initially set to 50000. Specify an even
number from 1024 to 65534. Two port numbers (the
number specified here and an odd number with 1 added
to the specified number) are actually used for video data
communication and control.
Audio port number
Specify the transmission port number of the audio data.
It is initially set to 50002. Specify an even number from
1024 to 65534. Two port numbers (the number specified
here and an odd number with 1 added to the specified
number) are actually used for audio data communication
and control.
Note
Specify different numbers for the video port number and
the audio port number.
fps
fps

Multicast streaming

fps
Set whether the camera uses multicast streaming for
MPEG4 images or not. It reduces the transmission load
on the camera by making the computer of the same
segment network receive the same transmitting data.
Select On to allow and Off not to allow multicast
sending.
When you select On, set Multicast address, Video port
number and Audio port number properly.
in the main viewer.