Starting Up The Software - Sony DFR-E3000 Operation Manual

Software Operation

Starting Up the Software

16(E)
To check the resource conflict
Point to Start, then Setup, and then point to Control Panel. Double-click
the System in the Panel window, then click the Device Manager tab.
Check that the LPT1 and COM1 are effective and no
!
displayed. When is displayed, the resources of COM1 and LPT1 may
conflict with other devices. In this case, resolve the conflict. For details,
refer to the help of Windows 95/98 or contact the manufacturer of the
computer or Microsoft Corporation.
Software installation
Before the installation of the software, be sure to connect all the
components and turn them on for the personal computer to check the
connection and obtain information of the connected components.
1
Turn off all the components to be connected.
2
Connect the DFR-E3000 to the LPT1 port of the computer using the
IEEE 1284 cable and DFR-C3000 to the COM1 port of the computer
using the RS-232C cross cable, respectively.
3
Turn on all the components and start up the Windows 95/98.
4
Insert the DFR-3000 SDDS RECORDER CONTROL SOFTWARE
CD-ROM in the CD-ROM drive.
The installation program starts up automatically. If it does not, point
to Start, point to the installation program, and then select "Run....," and
type "D:¥setup" into the dialog box (when the CD-ROM drive is drive
D) and press the Enter key or click the OK button.
5
Continue installation by following the instructions on the display.
Turn on all the components and start the Windows 95/98, Point to Start,
then Program, and then click DFR3000 SDDS RECORDER.
Record/Setup menu appears. If the menu does not appear, check the
connection of all the components and that the installation of the software
has been successful.
Click on the menu bar to access any of the menu items.
Record/Setup
• Click to display Record/Setup menu.
• Sets the input/output signals and recording parameters.
• Starts and stops the recording operation.
!
mark is
Menu bar