Important Precautions; Loading The Film - Sony DFR-E3000 Operation Manual

Sdds recorder system
Hide thumbs Also See for DFR-E3000:
Table of Contents

Advertisement

Available languages

Available languages

About the SDDS Recorder System
8 REMOTE I/O connector
Connect to the Westrex Camera System to output start
or stop command. For details, contact your nearest
Sony dealer or service personnel.
9 AC IN connector
Connect the AC power cord. For information on the
type of the AC power cord to be used, contact your
nearest Sony dealer or service personnel.
q; U (ground) connector
Used to ground the DFR-E3000.
qa SDIF-2 IN connector
Connect to the digital audio reproducer to input 8-
channel (8 lines) balanced SDIF-2 digital audio signal.

Important Precautions

Loading the Film

8(E)
qs ANALOG OUT connector
Connect to the monitor amplifier to output 8-channel
balanced analog audio signal.
qd WORD SYNC connector
Connect to the digital audio reproducer to output word
sync signal.
qf ANALOG IN connector
Connect to the analog audio reproducer to input 8-
channel balanced analog audio signal.
qg TIME CODE connector
Input time code for easy management of the recording
time.
qh AES/EBU IN connector
Connect to the digital audio reproducer to input 8-
channel (8 lines) balanced AES/EBU digital audio
signal.
• If your AC power supply is lower than 100 V or higher than 240 V,
contact the dealer from whom you purchased the system or service
personnel.
• Do not open the door of the DFR-C3000 or touch the belt while the film
is transporting.
Do the following procedure to load the film into the recorder:
1
Set the film magazine loaded with undeveloped film on the DFR-
C3000 and attach the belt behind the magazine.
2
Remove the T-reel side lid of the film magazine, open the door of the
Westrex RA-1231 Optical Sound Recording Camera, and then open
the door of the DFR-C3000 (in this order).
3
Pull out several feet of film from the S-reel and thread the film up to
the T-reel (the film should follow path indicated by the blue line inside
the DFR-C3000).
When threading the film onto the sprocket, turn the pressure arm
counterclockwise to allow the film to wind around the sprocket.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfr-c3000

Table of Contents