Sony J10 Installation Manual
I.link interface board
Hide thumbs
Also See for J10:
- Operation manual (57 pages) ,
- Brochure & specs (6 pages) ,
- Manual (120 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Sony J10
Summary of Contents for Sony J10
- Page 1 i.LINK INTERFACE BOARD HKJ-101 INSTALLATION MANUAL 1st Edition...
- Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
- Page 3 For the customers in the USA For the customers in Europe This equipment has been tested and found to comply with This product with the CE marking complies with the EMC the limits for a Class A digital device, pursuant to Part 15 Directive (89/336/EEC) issued by the Commission of the of the FCC Rules.
-
Page 5: Section 1 Installation
If this manual required, please contact your local Sony Sales Office/Service Center. 1-2. Installing the Circuit Board Procedure is different when installing HKJ-101 in J-H1 and J-H3. - Page 6 1-2-1. To install HKJ-101 in J-H1 5. Insert the CN-2478 board to the second slot from the bottom of J-H1. 1. Remove the six M3 case stopper screws. 6. Strongly push the connector panel both from the right 2. Remove the rear panel. and the left sides of the CN-2478 board so that the connector on the CN-2478 board is securely inserted Store the removed rear panel in a safe place so as not...
- Page 7 1-2-2. To install HKJ-101 in J-H3 4. Insert the connector (CN601) on the DV-29 board into the connector (CN41) on the SDI-80 assembly. 1. Remove the six M3 case stopper screws. 2. Remove the rear panel. First, insert the connector (CN401) on the DV-29 board to the hole for i.LINK connector on the IF panel.
- Page 8 8. Install the supplied rear panel for J-H3 using the six M3 case stopper screws . Tighten the screws in the state that the two dowels are aligned with the holes (a) and (b) on the rear panel as shown in the figure. Dowel M3 case stopper screws...
- Page 9 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 10 Printed in Japan Sony Corporation HKJ-101 (SY) J, E 2003. 7 16 B&P Company 3-805-991-01 ©2003...