2.
Remove the Phillips M2.0 × 2.5 screw (1) that secures the USB bracket.
3.
Remove the USB bracket that from the system board (2).
4.
Remove the two broad head Phillips M2.0 × 2.5 screws (3) that secure the system board to the
computer.
5.
Lift the left side of the system board until it rests at an angle (4), and then remove the system board by
pulling it up and to the left and out of the computer (5).
Reverse this procedure to install the system board.
46
Chapter 5 Removal and replacement procedures for authorized service provider parts