Mitsubishi SRK20ZSX-W Technical Manual page 116

③ Connect wires from X and Y terminals of R/C to X and Y terminals of indoor unit. R/C
wires (X, Y) have no polarity. Fix wires such that the wires will run around the terminal
screws on the top case of R/C.
④ Install the upper case with care not to pinch wires of R/C.
Cautions for wire connection
Use wires of no larger than 0.5 mm2 for wiring running
through the remote control case. Take care not to pinch
the sheath.
Tighten by hand (0.7 N·m or less) the wire connection.
If the wire is connected using an electric driver, it may
cause failure or deformation.
In case of exposing wiring
(When the wiring is taken out from the "upper center" or
"upper left" of R/C)
① Cut out the thin wall sections on the cases for the size of wire.
When taking the wiring out from the upper center, open a hole before separating the upper and bottom cases. This will reduce risk of
damaging the PCB and facilitate subsequent work.
When taking the wiring out from the upper left, take care not to damage the PCB and not to leave any chips of cut thin wall inside.
Upper center
上面中央の場合
上面左の場合
上ケース
② Fix the bottom R/C case on a flat surface with two wood
screws.
③ In case of the upper center, pass the wiring behind the
bottom case. (Hatched section)
④ Connect wires from X and Y terminals of R/C to X and Y
terminals of indoor unit. R/C wires (X, Y) have no polarity.
Fix wires such that the wires will run around the terminal
screws on the top case of R/C.
⑤ Install the top case with care not to pinch wires of R/C.
⑥ Seal the area cut in ① with putty.
上面中央の場合
Upper case
上ケース
下ケース
120mm
120 mm 左側の場合
(for retrieving wire
from upper left)
−7−
114
- -
ブッ シング
50
8
200
Wiring hole on
下ケース配線穴
bottom case
Upper left
上面左の場合
Bottom case
下ケース
190 mm
(for retrieving
190mm
wire from upper
中央の場合
center)
パテで シール
する こ と
'18 • SRK-T-234
リ モコ ン配線