Samsung DW80M9 Series Service Manual page 30

Part
Turbidity
sensor
28 _ Disassembly and Reassembly
Figure
Preparation :
•
•
•
•
•
1. Locate the Turbidity sensor through the Dish
2. Gently pry up the tabs on th turbidity sensor with a
Description
Make sure to disconnect the power, water supply.
Remove the Upper & Lower, 3rd baskets in the
dishwasher.
Pull out the dishwasher then lay the dishwasher
down on its back.
Remove the Housing left.
- Refer to the "Assy Case Brake" disassembly
section to separate Assy case brake until step 2.
Remove the Assy cover base.
- Refer to the "Assy cover base" disassembly section
to separate Assy cover base until step 2.
washer's leftside. Disconnect the wire terminal in red
box.
flat screw driver from the bottom.
Caution
Carefully use a flat tip screwdriver to pry the tabs
on the sensor as the tabs are fragile and can be
damaged easily.
Inspect the "O" ring seal around the sensor. If it is
damaged in anyway, replace the "O" ring seal.