2-7. PICTURE TUBE REMOVAL
9 Spring Extension
Speaker
4
Two screws
10 C board
3
12 Neck assy
14 Four Screws
Anode cap
5
15 Picture tube
7 DGC holders
8 Degaussing coils
6 Chassis assy
11 VM Board
13 Deflection
yolk
2 Speaker
Cushion
•
REMOVAL OF ANODE-CAP
Note : Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT
shield or carbon paint on the CRT, after removing the anode.
* REMOVING PROCEDURES.
a
1
Turn up one side of the rubber cap in
2 Using a thumb pull up the rubber cap
the direction indicated by the arrow a
firmly in the direction indicated by the
arrow b
•
HOW TO HANDLE THE ANODE-CAP
1
To prevent damaging the surface of the anode-cap do not use sharp materials.
2
Do not apply too great a pressure on the rubber, as this may cause damage to the
anode connector.
3
A metal fitting called a shatter hook terminal is fitted inside the rubber cap.
Do not turn the rubber foot over excessively this may cause damage if the shatter
hook sticks out.
1 Two screws
c
b
b
Anode button
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c