Table of Contents
Advertisement
(2) AIS transponder installation
Installation of the AIS transponder requires welding. In case of new shipbuilding, the installation can be
performed under its construction. (Refer to PAGE 3-1 in order to install). On existing ships, the AIS
transponder should be installed during periodical inspection because of welding. However, the
installation might be performed during navigation or at the quay within a short period of time. Here are
some countermeasures. (See below)
Rubbers (Attachment)
Ground bolt
(Dock supply)
Handrail
Figure 3
NTE-183
AIS Transponder
Fixing belts
(Attachment)
φ60.5
Tie-wraps
Spacer
(Prepared by
work front)
PREPARATION FOR INSTALLATION
① The pole for installation must be
adjusted
according
handrail's height.
② Refer to page 3-6 and fix the AIS
transponder
to
exclusive bands.
③ The pole for installation is fixed by
two or more stainless bands or
welded to the handrail and the
deck. (In case of stainless bands
and there is a space between the
handrail and the pole, insert a
spacer for stabilization.)
④ To run wires through a deck or a
wall, mount a cable grand and it
should be welded).
⑤ In case AIS is installed to the mast,
it is necessary to consider carefully
because the mast doesn't have
enough space and its handrail is
low generally.
to
the
the
pole
by
2-5
Hide quick links:
Advertisement
Table of Contents
