Location - York YLCA Series Technical Information

Location

Before locating the unit, make sure you have received the
appropriate product by checking the specifications described
on the outside of same.
The unit should be placed on a perfectly horizontal plane,
making sure the base can support the weight of the unit.
If vibration-free operation is required, the unit can be placed
on a cork or similar anti-vibratory base, or fastened to the
base with anti-vibratory plates or supports.
Location of several units
Avoid the recirculation of air between units.
OK
Fastening the unit
Before installing the unit, make sure the structure can support
the weight of same.
If the unit is to be placed on the floor, a concrete base should
be prepared so as to distribute weight evenly.
Place the unit on a consistent base and fasten by means of
bolts, using the four drilled holes at the base of the unit. Areas
where it snows regularly. If the unit is located outdoors and
at ground level, it should be placed on supports so as to avoid
obstruction of the air flow by an accumulation of snow. These
supports should be above the height the snow normally
reaches. It is convenient to install anti-snow grids.
24
NO
YLCA/YLHA PLUS 5, 7, 9, 12, 15, 20 and 27
NO
WITHOUT ANTI-SNOW
GRIDS (LOW PLATFORM)
Orientation
Orient the unit in the direction of the predominating winds.
Clearances
When installing each unit, clearances should be left for:
a) Air intake and discharge.
b) Maintenance servicing.
c) Power supply connections.
For proper operation, all minimum clearances shown on the
general dimension diagrams should be respected always
with regard to possible obstruction of air circulation of the
work of a user.
WITH ANTI-SNOW GRIDS
(HIGH PLATFORM)