Adding Track Marks Automatically (Auto Time Stamp) - Sony MZ-N1 OpenMG Jukebox NOTES on installing & operating Operating Instructions Manual

Adding track marks
automatically (Auto
Time Stamp)
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input
connector or a microphone.
• This function can be set with the
recorder only.
1
While the recorder is recording or in
recording pause, press the jog dial.
2
Turn the jog dial until "TIME
MARK" flashes in the display, and
then press to enter.
"OFF" flashes in the display.
3
Turn the jog dial until the desired
time interval flashes in the display,
and then press to enter.
Select one of the following intervals.
Display Time
OFF —
5 min. ON Approx. 5 min.
10 min. ON Approx. 10 min.
15 min. ON Approx. 15 min.
To cancel Auto Time Stamp
Select "OFF" in step 3 or stop recording.
Jog dial
Using Auto Time Stamp to add
track marks while recording
When the elapsed recording time
exceeds the time interval for Auto
Time Stamp:
The recorder adds track marks at the point
you set the time interval and from that
point the recorder adds a track mark
whenever the time interval has elapsed.
Example: Eight minutes of recording has
been completed when the Auto Time
Stamp time interval is set to 5 minutes.
A track mark will be added at the 8-
minute point (after the start of recording)
and after each 5-minute interval
thereafter.
When the time interval set for Auto
Time Stamp exceeds the elapsed
recording time:
The recorder adds track marks when the
set Auto Time Stamp time interval has
elapsed.
Example: Three minutes of recording has
been completed when the Auto Time
Stamp time interval is set to 5 minutes.
A track mark will be added at the 5-
minute point (after the start of recording)
and after each 5-minute interval
thereafter.
z
"T" appears before the time display on the
recorder for track marks added by Auto Time
Stamp, and "T" appears after the time display
on the remote control.
Notes
• Automatic track marking by Auto Time Stamp
starts when you add a normal track mark to
the disc (i.e., by pressing T MARK or flipping
the bar towards X, etc.).
• The setting will be lost when the recording
stopped.
35