Sony MZ-N1 OpenMG Jukebox NOTES on installing & operating Operating Instructions Manual page 81

Minidisc & dat walkman: netmd walkman player/recorder
Hide thumbs Also See for MZ-N1 OpenMG Jukebox NOTES on installing & operating:
Table of Contents

Advertisement

Symptom
No sound comes
through the
headphones/
earphones.
Volume cannot be
turned up.
An MD is not
played normally.
An MD is not
played from the
first track.
Playback sound
skips.
Sound has a lot of
static.
The rechargeable
battery does not
start charging.
The rechargeable
battery cannot be
fully charged.
The clock loses
time or the
display flashes.
The recording
date was not
stamped onto the
disc.
Cause/Solution
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i/LINE OUT.
• The plug is dirty.
, Clean the plug.
• The "AUDIO OUT" parameter for the i/LINE OUT jack is set to
"LINE OUT".
, Set to "HeadPhone".
• AVLS is on.
, Release AVLS settings (page 70).
• Playback mode is changed.
, Use the jog dial on the recorder or press RPT/ENT on the
remote control to change back to the normal play.
• Disc playing stopped before it came to the last track.
, Press N for 2 seconds or more to start playing, or press the
control towards . repeatedly on the remote.
• Group mode is turned on.
, Turn group mode off and play from the first track (press N for
2 seconds or more to start playing, or press the control towards
. repeatedly on the remote).
• The disc information has been stored to the Personal Disc Memory.
, Erase the disc information from the Personal Disc Memory.
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a track under one second long.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• The rechargeable battery has been inserted incorrectly or the AC
power adaptor has been connected incorrectly.
, Insert the battery correctly or connect the AC power adaptor
correctly.
• The terminals of the battery charging stand is dirty.
, Clean the terminals with a dry cloth (page 76).
• The built-in battery for the clock is weak.
, Connect the AC power adaptor to DC IN 3V on the recorder and
the wall outlet to charge the built-in battery. After charging, set
the clock again (page 38). Note that the clock may gain or lose
up to about 2 minutes per month under normal condition.
• The clock is not set.
, Set the clock (page 38).
81

Advertisement

Table of Contents
loading

This manual is also suitable for:

Walkman mz-n1

Table of Contents