Adding Track Marks Automatically (Auto Time Stamp) - Sony MZ-R410 Operating Instructions Manual

z
• To temporarily record without recording over
the current contents, press END SEARCH
before the start of recording. The recording
will begin after the last track, even if "R-Posi"
is set to "FrHere" (factory setting). The
remaining recordable time on the disc will
appear in the display when you press END
SEARCH.
• The recorder will not overwrite existing
material when group mode is on. In group
mode, you can only record tracks to create a
new group (page 23) or record tracks within
an existing group (page 24).
Notes
• The setting will remain even after the power is
turned off.
• If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused even when
the "R-Posi" is set to "Fr End".
Adding track marks
automatically (Auto
Time Stamp)
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input
connector.
> , .
1
While the recorder is recording or in
recording pause, press MENU.
2
Press > or . repeatedly until
"TimeMk" flashes in the display, and
then press ENTER.
3
Press > or . repeatedly until
the desired time interval flashes in the
display, and then press ENTER.
Select one of the following intervals:
Display Time
OFF —
5 min Approx. 5 min.
10 min Approx. 10 min.
15 min Approx. 15 min.
To cancel Auto Time Stamp
Select "OFF", and then press ENTER in
step 3, or stop recording.
MENU/
ENTER
25