Sony MZ-B10 Operating Instructions (primary manual) Operating Instructions Manual page 15

To
Record partway through the
previous recording
1)
Pause
Remove the MD
1)
The REC indicator flashes during recording pause. Track marks are not added while recording with
microphone, even when the recorder is paused.
If the recording does not start
• Make sure the recorder is not locked
(page 12).
• Make sure the MD is not record-protected
(page 46).
• Premastered MDs cannot be recorded over.
To know the recording
condition
The REC indicator lights up or flashes
according to the recording condition.
Recording
condition
While recording
Recording standby
Less than 3
minutes' recording
time available
A track mark has
1)
been added
1)
Except when track marking was done
manually or automatically using Auto Time
Mark (page 24).
Operation
Press N • PLAY, > • CUE • AMS or . •
REVIEW • AMS to find the beginning of the
material to be recorded, and then press X • PAUSE.
Press REC so that the recorder changes to recording
pause.
Press X • PAUSE again to start recording.
Press X • PAUSE while recording.
Press X • PAUSE again to resume recording.
x • STOP to stop recording, check if "TOC Edit"
has disappeared from the display, and then open the
lid.
REC indicator
lights up
flashes according
to the loudness of
the source while
recording with a
microphone
(voice mirror)
flashes
flashes slowly
goes off
momentarily
Notes
• For long recordings, it is recommended that
you power the recorder from a house current
using an optional AC power adaptor AC-
E30HG (page 43).
• The lid will not open during recording or until
"TOC Edit" disappears from the display after
the recording has completed.
• If the power supply is disrupted (i.e. the
batteries are removed or becomes exhausted
or the optional AC power adaptor is
disconnected) during a recording operation, or
while "TOC Edit" appears in the display, then
it will not be possible to open the lid until
power is restored and the x • STOP button is
pressed.
• "Data Save" or "TOC Edit" flashes while data
of the recording (the track's start and end
points, etc.) is being recorded. Do not move or
jog the recorder or disconnect the power
source while the indication is flashing in the
display. If you do, the material recorded up to
that point will not be saved to the disc.
• When you record through the microphone, the
various sounds made by the recorder may also
be recorded.
• The built-in microphone do not operate
whenever an optional microphone is
connected into the MIC (PLUG IN POWER)
jack on the recorder.
• The built-in microphone do not operate
whenever an optical cable or a line cable (not
supplied) is connected into the LINE IN
(OPTICAL) jack on the recorder.
15