Table of Contents
Advertisement
To attach the seat assembly:
1.
Slide the seat assembly onto the seat post (Figure 6).
2. Insert one bolt
into the underside of the seat slider and fully tighten it to set the travel limit (Figure 7).
3. Attach the seat slider end cap
Figure 6
To attach the handlebar assembly:
1.
Slide the handlebar assembly onto the handlebar post (Figure 9) by loosening the fore/aft handlebar knob and pulling it up to align with the grooves
on the handlebar post.
2. Insert one bolt
into the post and fully tighten it to set the travel limit (Figure 10).
3. Attach the handlebar post end cap
Figure 9
Attach the Pedals
Hold the pedals with the toe straps facing forward.
To attach the pedals:
1.
Insert a pedal into its corresponding crank arm (Figure 12).
2. Use a rubber mallet to lightly tap the center of the pedal into the crank arm to seat it (Figure 12).
3. Secure the pedal using one bolt
4. Repeat Steps 1-3 to attach the other pedal.
Level the Bike
Important Place the equipment on a flat surface. Rotating the adjustable feet does not compensate for extremely uneven surfaces.
Make sure the bike is level before allowing anyone to use it.
To level the bike:
1.
Try to rock the bike. If there is any movement, tip the bike to one side to locate the adjustable feet (Figure 14).
2. Correct the height of each adjustable foot by turning it clockwise (+) to lower the bike, or counterclockwise (-) to raise the bike.
3. When you are finished leveling the bike, place it on the floor. Recheck for movement and readjust as necessary.
Bike Assembly Checklist
Use this checklist to make sure your bike is assembled properly.
Check that all bolts are tightened to proper torque specification and no parts are missing.
Check that the handlebar and seat posts move freely and lock in different positions.
Check that the seat is level and does not rotate or tilt. Tighten and adjust as needed.
Test the seat for movement front to rear.
Brake tension is adjustable by turning the resistance knob in the front of the seat. Pressing down on the knob will apply the brake if you need to
stop quickly.
Pedal the bike at a moderate pace and test the resistance knob for smooth resistance changes.
Press down on the knob to ensure the bike stops quickly.
Once testing is complete, tip the bike forward using the handlebars and roll it on a smooth surface to its final use location. Turn the adjustable feet to level
the bike.
Spinner® Rally and Spinner® Shift Assembly Guide | P/N 305002-103 rev C, ENU
©2016 Precor Incorporated | January 2016
using three bolts
(Figure 8) and fully tighten with the hex key
Figure 7
using two bolts
(Figure 11) and fully tighten with the hex key
Figure 10
(Figure 13) and torque to 33 ft-lb (45 N-m) with the hex key
.
Figure 8
.
Figure 11
.
Figure 12
Figure 13
Figure 14
Advertisement
Table of Contents
