CHASSIS
7.1.18 REMOVING THE IGNITION SWITCH/
STEERING LOCK
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
N
Turn the steering all the way over to the left.
N
Turn the ignition switch to position "1".
N
Release the wiring from the two fastening clamps (1)
(2).
NOTE
Prepare the same number of clamps, which will
be required for reassembly.
N
Lift the protection element (3).
N
Disconnect the electric connector (4).
a
CAUTION
When reassembling, make sure the connector is
plugged in properly.
N
Unscrew and remove the screw (5) and take the bush-
ing.
NOTE
When reassembling, position the cable guide
(6) correctly.
N
Use a chisel to cut into the head of the special screw
(7) and turn it until it loosens.
N
Unscrew the screw (7) by hand and remove it.
NOTE
When reassembling, use another screw of the
same type, tightening it until the head comes off.
N
Remove the ignition switch/steering lock (8), sliding it
out form underneath.
7
- 18
- 00
RSV mille
Release 00/2002-10