Removing The Battery; Removing The Electronic Unit - APRILIA RSV mille Workshop Manual

CHASSIS

7.1.8 REMOVING THE BATTERY

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 2.4 (BATTERY).
NOTE
To remove the battery it is necessary to set to
zero the digital clock and the red line setting.
To reset these functions, see 2.3 (MULTIFUNCTION
COMPUTER).
N
Turn the ignition switch to position "1".
N
Put back the rider saddle, see 7.1.1 (REMOVING THE
RIDER SADDLE).
N
Unscrew and remove the screw (1) on the negative ter-
minal (–).
N
Move the negative cable (2) sidewards.
N
Remove the red protection element (3).
N
Unscrew and remove the screw (4) on the positive ter-
minal (+).
N
Move the positive cable (5) sidewards.
N
Unscrew and remove the screw (6).
Screw (6) driving torque: 3 Nm (0.3 kgm).
N
Remove the bracket (7) that locks the battery.
NOTE
If the inner foam edging appears damaged, re-
place it.
N
Grasp the battery (8) firmly and remove it from its com-
partment by lifting it.
a
CAUTION
Upon reassembly, connect first the positive cable (+)
and then the negative cable (–).
a
WARNING
Once it has been removed, the battery must be stored
in a safe place and kept away from children.
N
Position the battery on a flat surface, in a cool and dry
place.

7.1.9 REMOVING THE ELECTRONIC UNIT

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Turn the ignition switch to position "1".
N
Put back the rider saddle, see 7.1.1 (REMOVING THE
RIDER SADDLE).
N
Remove the upper protection element (9).
N
Disconnect the two electric connectors (10) (11) from
the electronic unit (12).
a
CAUTION
When reassembling, make sure the two electric con-
nectors (10) (11) are plugged in properly.
N
Remove the electronic unit (12), lifting it out of the com-
partment under the rider's saddle.
7 - 10
- 00
RSV mille
Release 00/2002-10