Sony 5500 Operation Manual page 160

Item number Item
743 BLACK LEVEL
(ALL)
(HD/UC/SD/DC)
preset: 100%
(4000H)
755 MASTER LEVEL
(D1)
preset: 100%
(4000H)
756 Y LEVEL (D1)
preset: 100%
(4000H)
757 B–Y LEVEL (D1)
preset: 100%
(4000H)
758 R–Y LEVEL (D1)
preset: 100%
(4000H)
762 SETUP LEVEL
(CST)
preset: 7.5 IRE
763 SYNC PHASE (SD)
preset: 0
764 FINE (SD)
preset: 0
775 VIDEO OUTPUT
DATA
160
Menu List
Setting Function
–31.0% (0H) Adjusts the black level of HD, UC, SD, and DC output.
[0$110H%]
Note
The range of control possible from the HKDV-900/503 is
31.0% (220H)
–8.0% to 8.0%.
0.0% (0H) Adjusts the level of the high D1 video signal output from SD
SDI OUT and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y, B–Y, and R–Y level.
[100 4000H ]
% ( )
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI
OUT and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y levels.
[100 4000H ]
% ( )
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI
OUT and FORMAT CONV. OUT (OPTION) connectors.
Adjusts the B–Y level of the video signal.
[100 4000H ]
% ( )
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI
OUT and FORMAT CONV. OUT (OPTION) connectors.
Adjusts the R–Y level of the video signal.
[100 4000H ]
% ( )
141.3% (5A70H)
0.0 Adjusts the setup level of the analog composite video
signal output from SD OUT COMPOSITE (MONITOR)
connector.
[7.5]
10.0
–128 Adjusts the sync phase of the D1 video signal output from
SD SDI OUT and FORMAT CONV. OUT (OPTION)
connectors and analog composite video signal output from
[0]
SD OUT COMPOSITE (MONITOR) connector.
127
[0]
Makes fine adjustments to the sync phase of the D1 video
signal output from SD SDI OUT and FORMAT CONV. OUT
(OPTION) connectors and analog composite video signal
1024
output from SD OUT COMPOSITE (MONITOR) connector.
8bit Sets the bit size of the output data from the HD-SD
[10bit] converter.
8bit: When connected to an 8-bit system
10bit: When connected to a 10-bit system
Notes
• Make sure the bit length matches the destination device.
• This setting is only active when the HD-SD converter
output is set to D1.