Sony 5500 Operation Manual page 150

Item number Item
304 VAR SPEED RANGE
FOR
SYNCHRONIZATION
305 EDIT FIELD select
306 SYNCHRONIZE
311 EDIT PRESET
REPLACE MODE
SELECT
312 ANALOG AUDIO
EDIT PRESET
REPLACE
Sub items
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH9
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH10
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH11
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH12
150
Menu List
Setting Function
[-1 to +2] Specifies the variable tape speed range when the variable
–1.15 to +2.45 speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
–1 to +2: –1 to +2 times normal tape speed
–1.15 to +2.45: –1.15 to +2.45 times normal tape speed
Note
When an editing control unit such as BVE-9100 is
connected for DT editing, select "–1.15 to +2.45".
[1F]
Selects the start timing for editing when performing tape
2F editing.
1F/2F 1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
rough another VTR connected through a 9-pin remote cable, this
off selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
[normal]
normal: Assigns edit preset command channels 1 to 8, to
parallel
reverse parallel: Assigns edit preset command channels 1 to 4, to
stereo
reverse: Assigns edit preset command channels 1 to 4 to
stereo: Assigns edit preset command channels 1 to 4 to
[no def]
When the edit presets for VTR channels 9 to 12 are
ch1 specified by an editor or remote controller, these are set on
ch2 or off according to the analog audio edit presets.
ch1+2 no def: Not set.
ch1: Follows analog channel 1 edit preset.
ch2: Follows analog channel 2 edit preset.
ch1+2: Follows the edit preset for analog channel 1 or
frames.
track channels 1 to 8.
channel pairs 1/5 to 4/8.
channels 5 to 8, and channels 5 to 8 to channels 1 to 4.
track channel pairs 1/2 to 7/8.
analog channel 2.