Agri-Fab 45-0270 Owner's Manual page 6

19. Assemble the R.H. axle spindle to the front axle
channels using two split plastic bearings, two
small 3/4" flat washers and a cotter pin as shown
in figure 7. Repeat for L.H. axle spindle.
20. Tighten the two 3/8" x 4" hex bolts assembled in
step 17. Do not tighten the 1/2" x 4-1/2" center
hex bolt.
3/4" FLAT
WASHER
(SMALL)
SPLIT
PLASTIC
BEARINGS
3/4" FLAT
WASHER
(SMALL)
FIGURE 7
21. Place the front axle channels between the front
axle supports. Assemble two 5/16" x 2-1/2" hex
bolts through the holes in the ends of the supports
and secure with 5/16" lock washers and 5/16" hex
nuts. Do not tighten. See figure 8.
5/16" x 2-1/2"
HEX BOLT
5/16" LOCK
WASHER
FIGURE 8
COTTER PIN
L.H. AXLE
SPINDLE
R.H. AXLE
SPINDLE
5/16"
HEX
NUT
22. Assemble the tongue reinforcement angle to the
back side of the front axle supports as shown in
figure 9. Use two 5/16" x 2-1/2" hex bolts, 5/16"
lock washers and 5/16" hex nuts. Do not tighten.
23. Make sure the center bolt (pivot bolt) is inserted as
far as possible through the axle channels and then
tighten the four bolts assembled in steps 21 and
22. Next, tighten the eight bolts assembled in
step 16, which fasten the front axle supports to the
cart bed.
PIVOT BOLT
TONGUE
REINFORCEMENT
ANGLE
5/16" LOCK
WASHER
FIGURE 9
24. Assemble the front panel over the end of the cart
using eight 1/4" x 1/2" hex bolts and 1/4" (SEMS)
hex nuts. Tighten the bolts in the bottom of the
panel and then tighten the bolts in the sides. See
figure 10.
25. Assemble two corner caps to the front of the cart
using four 1/4" x 1/2" hex bolts and 1/4" (SEMS)
hex nuts. Tighten. See figure 10.
1/4" x 1/2"
HEX BOLT
CORNER
CAP
1/4" (SEMS)
HEX NUT
FIGURE 10
6
5/16" x 2-1/2"
HEX BOLT
1/4" (SEMS)
HEX NUT
5/16"
HEX
NUT