Table of Contents
Advertisement
RUGGEDCOM RS900GF
Installation Guide
The serial console port implements RS-232 DCE (Data Communication Equipment) on a DB9 connector. Use the
following settings to connect to the port:
Speed
Data Bits
Stop Bit
Parity
Flow Control
Terminal ID
Speed
The following is the pin-out for the port:
Figure 8: Serial DB9 Console Port
a
Connected internally.
b
Connected internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROS console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RS900GF is https://192.168.0.1.
For more information about available ports, refer to
Section 2.8
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
Configuring the Device
57600 Mbps
8
1
None
Off
VT100
57600 Mbps
5
1
9
6
Pin
a
1
2
3
a
4
5
a
6
b
7
b
8
9
Chapter 3, Communication
Installing the Device
Name
Description
Reserved (Do Not Connect)
TX
Transmit Data
RX
Receive Data
Reserved (Do Not Connect)
GND
Signal Ground
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Ports.
Chapter 2
13
Advertisement
Table of Contents
