Chapter 2
Installing the Device
Section 2.4.2
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS900GF can be equipped with panel adapters that allow the device to
be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
Loosen the screws for the panel adapters located at the top and bottom of the device.
Figure 3: Installing the Panel Adapters
1. Panel Adapter 2. Screw
2.
For both adapters, align the slots with the screws and then slide the adapters onto the device.
3.
Tighten the screws to secure the adapters.
4.
Place the device against the panel and align the adapters with the mounting holes.
Figure 4: Panel Mounting
1. Panel Adapter 2. Screw
8
1
1
1
2
2
2
RUGGEDCOM RS900GF
Installation Guide
2
1
Mounting the Device to a Panel