Sony HDCU4300 Operation Manual page 45

MAINTENANCE menu
MAINTENANCE
Page name Item
Page No.
<I/F SETTINGS> SLOT3
M01
CHARACTER/SYNC
OUT
MIC/WF REMOTE
REAR PREVIEW
<TRUNK/PROMPTER1> TRUNK LINE
M02
PROMPTER
<TRUNK/PROMPTER2> NETWORK TRUNK
M03
HD PROMPTER
HD TRUNK
Set value
Top (for SDI I/O 1): OUTPUT,
RET3/HD-PROMPTER
Bottom (for SDI I/O 2): OUTPUT,
HD-TRUNK, RET4
CHARACTER, SYNC
MIC REMOTE, WF REMOTE
MOMENTARY, TOGGLE
CHANNEL MODE 2CH(MAX 75Kbps), 1CH(MAX
150Kbps)
INTERFACE 232C, 422A
CHANNEL MODE 2CH, 1CH
MODE OFF, NETWORK,
NETWORK+VIDEO
DATA RATE 100Mbos, 1Gbps
(ENABLED), (DISABLED)
(ENABLED), (DISABLED)
Description
Sets the functions to assign to the SLOT3
connectors.
The top one is the SDI I/O 1 connector setting.
The bottom one is the SDI I/O 2 connector setting.
OUTPUT: Used as the SLOT3-1 and SLOT3
outputs.
HD-TRUNK: Used as the HD-TRUNK output.
RET3/HD-PROMPTER: Used as both the RET3
input and HD-PROMPTER input connector.
RET4: Used as the RET4 input connector.
Note
When this is set to RET3/HD-PROMPTER, the same
image will be used for the camera's RET3 and HD
PROMPTER outputs.
Sets the function to assign to the CHARACTER/
SYNC OUT connector.
CHARACTER: Set to VBS (CHARACTER
superposition) output.
SYNC: Set to SYNC OUT output.
Displayed only when a 50-pin board is installed.
Sets the operation mode of REAR PREVIEW
connector output.
Sets the number of channels to be used.
Sets the communication line mode.
Sets the number of prompter lines.
Sets the mode for the network trunk.
OFF: Network TRUNK is not used.
NETWORK: Network Trunk is used (maximum
1 Gbps)
NETWORK+VIDEO: Network trunk is used at the
same time as HD Trunk/HD Prompter (maximum 100
Mbps)
Displays the data transfer rate. (Display only)
Displays "ENABLE" or "DISABLE" for HD
PROMPTER. (Display only)
Displays "ENABLE" or "DISABLE" for HD TRUNK.
(Display only)
45