Sony HDCU4300 Operation Manual page 35

SYSTEM OPERATION
Page name Item
Page No.
<HD CUTOUT> HD CUTOUT
S08
MODE
CUTOUT POSITION
CH
CUTOUT POSITION
CENTER H
CUTOUT POSITION
CENTER V
CUTOUT POSITION
ZOOM
CAMERA TILT
CAMERA ROLL
FOCAL LENGTH
Set value
OFF, ON
SIMPLE HD,
ZOOM&PERSPECTIVE
1, 2
–1536 to 1535, 0
–810 to 809, 0
1.0 to 4.0, 2.0
–45.0 to 45.0, 0
–5.0 to 5.0, 0
7 to 500, ∞
35
Indication
Turns the HD cutout function ON/OFF.
Enabled only when HDC(HD CUTOUT) is selected in
CHU MODE.
The cutout HD signal from the 4K source is output
from SLOT1.
Selects the cutout mode.
SIMPLE HD: Outputs a 1920×1080 HD region cutout
from the 4K video as-is. Dual output is supported.
The cutout signal set by the CUTOUT POSITION
CH1 setting is output from the 1/2 connector and 5/6
connector of Slot1, and the cutout signal set by the
CUTOUT POSITION CH2 setting is output from the
3/4 connector and 7/8 connector of Slot1.
ZOOM&PERSPECTIVE: Outputs an HD signal
formed by zooming in or out of the cutout region from
the 4K video. In this mode, a perspective
transformation is performed according to the focal
length of the lens, and an image similar to the image
obtained by the camera facing the cutout direction is
output.
Selects the cutout position channel.
Only channel 1 is available when
ZOOM&PERSPECTIVE is selected.
Specifies the cutout position center (horizontal
direction, 0: center).
(Setting when MODE is ZOOM&PERSPECTIVE,
CUTOUT POSITION ZOOM is 4.0, and FOCAL
LENGTH is Infinity)
Specifies the cutout position center (vertical
direction, 0: center).
(Setting when MODE is ZOOM&PERSPECTIVE,
CUTOUT POSITION ZOOM is 4.0, and FOCAL
LENGTH is Infinity)
Specifies the zoom factor (1.0: same position as the
4K video)
Enabled only when ZOOM&PERSPECTIVE is
selected.
Specifies the tilt angle of the camera (0: horizontal,
positive angles represent upward tilt)
Enabled only when ZOOM&PERSPECTIVE is
selected.
Specifies the roll angle of the camera (0: horizontal,
positive values represent counterclockwise roll)
Enabled only when ZOOM&PERSPECTIVE is
selected.
Specifies the focal length of the lens (unit: mm)
To avoid shape change due to perspective
transformation, increase the focal length until
"INFINITY" is displayed.
Enabled only when ZOOM&PERSPECTIVE is
selected.