Grizzly G0793 Owner's Manual page 36

4. Fill headstock with oil to red mark on sight
glass (see Figure 39).
Oil-Level
Sight Glass
Figure 39. Red mark on sight glass indicates
headstock oil level is full.
5.
Re-install oil fill plug.
6.
Discard used oil following federal, state,
and fluid manufacturer guidelines for proper
disposal.
-34-
Downfeed Gearbox
Oil Type ......Model T23963 or ISO 32 Equivalent
Oil Amount ...............................................
Lubrication Frequency ........................... Annually
The gear box uses an oil pump to lubricate the
gears. For this machine, use ISO 32 machine
Red Mark oil. Check the oil level every day (see Step 4).
Change oil annually.
Tools Needed
Hex Wrench 6mm .............................................. 1
Hex Wrench 8mm .............................................. 1
Drain Pan (2-Gallon or Larger) .......................... 1
To change oil in gearbox:
1.
Sight Glass
Figure 40. Gearbox oil fill, drain and sight glass
2.
3.
4.
Do not fill gearbox with oil above red mark.
This could damage the machine and create
an overflow of oil.
Remove oil fill plug on top of the gearbox
(see Figure 40).
Oil Fill Plug
Oil Drain Plug
locations.
Position drain pan under drain plug and then
remove drain plug. Allow old oil to drain into
drain pan.
Replace and tighten drain plug.
Fill headstock with oil to red mark on sight
glass (see Figure 40).
Model G0793 (Mfd. Since 02/15)
⁄ quart
1
2
Qty