Sony XDCU-50 Operating Instructions Manual page 15

Pin number Signal name
7 TALLY(GND)
14 G TALLY IN
15 R TALLY IN
11 4W(G)
13 4W(X)OUT
12 4W(Y)OUT
18 4W(G)
19 4W(X)IN
21 4W(Y)IN
10 CLEAR COM(X)IN/OUT
23 CLEAR COM(G)
25 RTS IN/OUT
24 RTS(G)
20 NC
22 NC
4 Reserved
5 Reserved
c GENLOCK INPUT connectors (BNC type)
Input an external sync signal, either an HD tri-level
reference sync signal or an SD reference sync signal (black
burst signal). The two connectors have a loop-through
configuration. The signal input to the input side connector
is output unchanged to the output side connector (
When nothing is connected to the output side connector,
the input signal is terminated automatically (75
termination).
d OUTPUT SDI connectors (BNC type)
Output video, audio, and timecode received from the
camcorder via the camera adaptor is output as HDSDI or
SDSDI signals.
e CA (camera adaptor) connector (CCZ 26-pin)
Connect to the CEU connector of the camera adaptor with
a optional CCZ-A cable. This cable supplies DC power to
the camcorder via the camera adaptor.
This connector also provides general-purpose lines
between this unit and the camera adaptor.
For details about the general purpose lines, see "AUX
connector" (page 14).
For details about the pin assignments of the CA connector,
contact a Sony service representative.
f - AC IN connector (3-pin)
Connect to an AC power source with the specified power
cable.
Description
Tally input
On: GND
Off: Open
4-wire interface system output
4-wire interface system input
Clear-Com system interface (requires termination, recommended
impedence 200 Ω)
RTS system interface (requires termination, recommended
impedence 200 Ω)
Not used
Pins reserved for maintenance
g CA OUT (camera adaptor output) connector (BNC
type)
Connect to the CEU IN connector of the camera adaptor
using a BNC cable.
h CA IN (camera adaptor input) connector (BNC
).
type)
Ω
Connect to the CEU OUT connector of the camera adaptor
using a BNC cable.
i RETURN INPUT SDI connector (BNC type)
Input HDSDI or SDSDI return video signals.
For details, see "Return Video Signal Input and Output"
(page 21).
j RETURN INPUT VIDEO connector (BNC type)
Input SD analog composite return video signals.
For details, see "Return Video Signal Input and Output"
(page 21).
k VIDEO OUTPUT connector (BNC type)
Output video signals received from the camcorder via the
camera adaptor as SD analog composite signals.
The following table lists the signal formats of the SD
analog composite signals output from this connector.
System format (number of
system lines/frame rate)
1080/59.94i
720/59.94P
Signal format
NTSC (525/59.94i)
Names and Functions of Parts
15