Table of Contents
Advertisement
i LINK indicator
Lights in green when a data transfer link between this unit
and a camera adaptor has been established, and when
device authentication between the camera adaptor and the
camcorder has been established.
System setting switches
Use the supplied front cover to protect the system setting
switches from misoperation.
Check the setting of the individual switches and change the
switch setting as required, then attach the front cover to the
SYSTEM SETUP switches
Set up the system format of this unit (number of system
lines/frame rate) to match the system format of the
camcorder.
For details, see "Setting the System Format" (page 19).
OUTPUT SELECT switches
Make settings related to the output signals of this unit.
DOWN CONVERTER ADJUSTMENT switches
Specify the methods used to adjust down converted
signals. These adjustments are applied to SDSDI signals
output from the OUTPUT SDI connectors and to SD
analog composite signals output from the VIDEO
OUTPUT and REMOTE connectors.
12
Names and Functions of Parts
Front cover
Front cover attachment screws
Switch name
Settings
1080i/720p
1080i: Interlace mode, 1080
lines
720p: Progressive mode, 720
lines
59.94/50
59.94: 59.94 Hz (NTSC area)
50: 50 Hz (PAL area)
Switch name
Settings
HD/SD
HD: HDSDI signals
SD: SDSDI signals
WIDE ID
ON: Add a wide ID signal when
the aspect ratio is 16:9, and
do not add a wide ID signal
when the aspect ratio is 4:3
OFF: Never add a wide ID signal
SETUP (NTSC
ON: Add setup
area only)
OFF: Do not add setup
front panel of the unit with the supplied front cover
attachment screws.
Description
Sets the number of system lines.
Sets the system frequency.
Description
Selects the type of signals output from the
OUTPUT SDI connectors of this unit.
Specifies whether to add a wide ID signal
to composite signals output from the
VIDEO OUTPUT and REMOTE
connectors, and to SDSDI signals output
from the OUTPUT SDI connectors.
When you are using the unit in an NTSC
area, specifies whether to add a 7.5%
setup to the composite signals output from
the VIDEO OUTPUT and REMOTE
connectors.
Note
The settings of these switches do not affect the signals
output from the OUTPUT SDI connectors when those
signals are HDSDI signals.
Advertisement
Table of Contents
