Table of Contents
Advertisement
Installation and Connection of the Switcher
Installing an Interface Board
Interface boards and available card slots
To install an interface board
40
Installation and Connection of the Switcher
This section describes installation and connection of the switcher.
Install an optional interface board in the card slot at the rear of the Processor
Unit. The Processor Unit has three card slots at the rear. Some of the interface
boards are restricted with regard to installation in some of these three card slots.
IN1 card slot
IN2 card slot
IN1
IN2
1
2
3
4
PGM1
PGM2
AUX1
SDI IN
SDI OUT
Interface board
BRSA-20HSD1 HD/SD-SDI
input board
BRSA-20DD1 DVI input
board
BRSA-20DD2 DVI output
board
Yes: can be installed, No: cannot be installed
Notes
• Be sure to turn off all the equipment before attaching or removing an interface
board.
• Immediately after the switcher has been turned off, the Processor Unit is
hot. Be sure to wait more than 30 minutes after the switcher is turned off
before you open the top cover of the Processor Unit.
• Do not remove any panels inside other than the top panel of the Processor
Unit.
• Be sure to use the attachment screws supplied with an interface board to install
it in the card slot. Using other screws may cause damage to the interface board
and the Processor Unit.
• When installing the interface board, be careful not to injure yourself.
OUT card slot
OUT
GPI I/O
PANEL
LAN(10/100)
REMOTE
AUX2
REF IN
GENLOCK
Card slot
IN1
IN2
Yes
No
Yes
Yes
No
No
~
AC IN
DVI-I OUT
RS-232C
REF OUT
RS-422
VISCA
OUT
No
No
Yes
Advertisement
Table of Contents
