Audio Set Menu - Sony EXMOR PMW-EX1 Operating Instructions Manual

CAMERA SET
Menu items
Steady Shot
Setting the image
stabilizer

AUDIO SET Menu

AUDIO SET
Menu items
Audio Input
Setting for audio
inputs
Audio Output
Setting for audio
outputs
102 Setup Menu List
Subitems and setting values Contents
On / Off
Subitems and setting values Contents
TRIM CH-1
–8 dBu to –65 dBu (–41 dBu)
TRIM CH-2
–8 dBu to –65 dBu (–41 dBu)
AGC Link
Linked / Separated
1KHz Tone
On / Off
Wind Filter CH-1
On / Off
Wind Filter CH-2
On / Off
EXT CH Select
CH-1
CH-1/CH-2
Monitor CH
CH-1/CH-2 (CH-3/CH-4)
CH-1+CH-2 (CH-3+CH-4)
CH-1 (CH-3)
CH-2 (CH-4)
Output CH
CH-1/CH-2
CH-3/CH-4
Alarm Level
0 to 10 (5)
Beep
On / Off
Turn the Steady Shot (image stabilizer) function on/off.
Finely adjust the sensitivity of channel 1 of external
microphone input in steps of 3 dB.
Finely adjust the sensitivity of channel 2 of external
microphone input in steps of 3 dB.
Select the gain link condition when the audio level adjustment
is in AGC mode.
Linked: To vary the CH-1 gain and the CH-2 gain in
synchronization.
Separated: To vary the CH-1 gain and the CH-2 gain
independently according to the respective levels.
Turn the 1-kHz reference tone signal on/off.
Turn the wind filter for channel 1 on/off.
Turn the wind filter for channel 2 on/off.
CH-1: To record channel 1 audio input on both channels 1
and 2.
CH-1/CH-2: To record channel 1 and channel 2 inputs on the
respective channels.
Select the audio channel(s) to be fed to the headphones and
the built-in speaker.
CH-1/CH-2 (CH-3/CH-4): Stereo
CH-1+CH-2 (CH-3+CH-4): Mix
CH-1 (CH-3): CH-1 (CH-3) only
CH-2 (CH-4): CH-2 (CH-4) only
( ): with Output CH set to "CH-3/CH-4"
Select audio output channels from either channels 1 and 2 or
channels 3 and 4.
Set the alarm sound volume.
Select whether or not to sound a beep upon each operation.