Recording With A Shot Transition - Sony EXMOR PMW-EX1 Operating Instructions Manual

Off: Not to link to recording start
(To use the A or B button to start the
transition and specify the target shot)
Shot-A: To start the transition to Shot A in
synchronization with recording start
Shot-B: To start the transition to Shot B in
synchronization with recording start
3
Exit the menu to finish the settings.
Registering a shot
You can register two kinds of shots: A and B.
1
Press the MODE button to display
"Store" in the shot-transition operation
area.
2
Adjust the camera settings to obtain an
image you wish to register.
3
When adjustment is finished, press the
Shot A or Shot B button.
The camera settings are registered to the pressed
button.
The registered camera settings are maintained
until you register them next.
Checking the Registered Settings (Shot)
1
Press the MODE button to display
"Check" in the shot-transition
operation area.
2
Press the A or B button, whichever you
assigned to the shot you wish to check.
The selected shot (camera settings or conditions)
takes effect on the picture on the screen.
With this operation, you cannot check the
conditions of the transition.

Recording with a Shot Transition

When the preparatory settings are completed, you
can start recording.
Operations differ depending the "Rec Link"
setting.
66 Shot Transition
Making a transition from the current
picture to a registered shot
1
Adjust the camera settings to obtain an
image with which you wish to start
recording.
2
Press the MODE button to display
"Execute" in the shot-transition
operation area.
3
Press the REC START/STOP button.
Recording begins.
4
When "Rec Link" is "Off," press the
button of the target shot (A or B) when
you wish to start the shot transition.
The current camera settings are gradually
shifted to those registered to the specified
shot.
When "Rec Link" is "Shot-A" or "Shot-
B," the camcorder automatically performs
the shot transition to the camera settings
registered to Shot A or Shot B, respectively.
You need not press the button.
Notes
• You cannot return to the status in step
after you start the shot transition. If the status
must be resumed, register it as a shot.
• When you perform recording on an external
device connected via the i.LINK(HDV)
connector in synchronization with REC
START/STOP operations on this camcorder,
recording start on the external device and shot-
transition start may not be synchronized even if
"Rec Link" has been set to "Shot-A" or "Shot-
B," depending on the performance of the
external device.
Making a transition from Shot A to Shot B
When "Rec Link" is set to "Off" or "Shot-B," a
shot transition from Shot A to Shot B is possible.
1
Press the MODE button to display
"Check" in the shot-transition
operation area.
2
Press the A button.
The picture is adjusted according to the
camera settings registered for Shot A.
1
once