Sony EXMOR PMW-EX1 Operating Instructions Manual page 108

OTHERS
Menu items
Tally
Setting the tally
lamps
Hours Meter
Displaying the
hours meter
IR Remote
Activating/
deactivating the
Remote
Commander
Battery Alarm
Setting the low
power alarm
Battery INFO
Showing
information
regarding the
battery pack
(display only)
Direct Menu
Setting the Direct
menu function
i.LINK I/O
Setting for input/
output at the
i.LINK connector
108 Setup Menu List
Subitems and setting values Contents
Front
High / Low / Off
Rear
On / Off
Hours (Sys)
Hours (Reset)
Reset
Execute/Cancel
On / Off
Low BATT
5% / 10% / 15% / ... / 45% /
50%
BATT Empty
3% to 7% (3%)
DC Low Volt1
11.5 V to 17.0 V (11.5 V)
DC Low Volt2
11.0 V to 14.0 V (11.0 V)
Type
MFG Date
Charge Count
Capacity
Voltage
Remaining
All / Part / Off
Enable / Disable
Set the brightness of the tally lamp on the front.
High: To brighten the lamp
Low: To dim the lamp
Off: To not light the lamp
Turn the tally lamp on the rear on/off.
The non-resettable accumulated time of use is displayed.
The resettable accumulated time of use is displayed.
Select "Execute" to reset the Hours (Reset) value to 0.
Set to "On" to activate remote control operations from the
supplied IR Remote Commander.
Note
The setting automatically returns to "Off" when the
camcorder is turned off.
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
Set the battery level at which the BATT Empty warning is
generated.
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
The type (product name) is displayed.
The date of manufacture is displayed.
The accumulated number of times of charge/discharge is
displayed.
The estimated total capacity of full charge is displayed.
The current output voltage is displayed.
The current remaining level is displayed.
All: All Direct menu operations are permitted.
Part: A part of Direct menu operations is permitted. The
operation is limited depending on the GAIN, SHUTTER,
or WHITE BAL switch setting.
Off: No Direct menu operation is permitted.
Enable: To use the i.LINK connector
Disable: To not use the i.LINK connector
Notes
• When you set this item to "Enable," no signal is fed out
from the SDI OUT connector.
• When the video format is not SP mode, signal input/output
via the i.LINK connector is not enabled, even if this item is
set to "Enable."