Section 5: Provisioning Tp-Link - TP-Link TL-MR3040 Instructions

3. When prompted, authenticate with:
Username: admin

This information can be found on the Default Settings
sticker under the battery cover

If no prompt appears, confirm:
A. TP-Link has power and is turned on
B. Wi-Fi is turned on and connected
C. No static IP is set for TP-Link's Wi-Fi network
D. TP-Link has been restored to factory defaults (as
explained in Section 1)
4. Continue to Section 5 to provision TP-Link

Section 5: Provisioning TP-Link

1. Navigate to Operation Mode in the left-hand
navigation bar
2. Change Operation Mode to WISP Client Router
Mode and click Save

After clicking Save, TP-Link will reset (will take
approximately one minute)

If webpage fails to appear after reboot when
using Wi-Fi, make sure that TP-Link is still the
device's active connection
3. Navigate to Network in the left-hand navigation bar,
then select LAN from Network's submenu
4. Change IP Address to

After clicking Save, TP-Link will reset (will take
approximately one minute)

After saving, you must go to
configure device (instead of 192.168.0.1)

If webpage fails to appear after reboot when
using Wi-Fi, make sure that TP-Link is still the
device's active connection

If webpage still fails to appear after reboot and device is connected, forget the network
connection on user's device, then try again
5. Navigate to DHCP in the left-hand navigation bar, then select DHCP Settings from DHCP's submenu
6. Confirm/Set the following (if any changes made, user must perform steps 9 & 10):
A. DHCP Server is enabled
B. Start IP Address is set to 192.168.100.100
C. End IP Address is set to 192.168.100.199
7. Navigate to Wireless in the left-hand navigation bar, then select Wireless Security from submenu
8. Select Disable Security to remove any Wi-Fi password

If a password is desirable, select WPA/WPA2 – Personal and enter desired password

If any changes made, user must perform steps 9 & 10
9. Navigate to System Tools, then select Reboot from System Tools' submenu
10. Click Reboot to reboot device and commit any changes made in steps 5-8

If webpage fails to appear after reboot when using Wi-Fi, make sure that TP-Link is still the device's
active connection
Password: admin
192.168.100.5 and click Save
192.168.100.5
F
IGURE
to
F 9: TP-L
IGURE INK
8: OS W -F D
I I I ETAILS
C S -S
ONFIGURATION TART CREEN
Page 4 | 03/16