Bfd Interval - Cisco Nexus 7000 Series Command Reference Manual

B Commands

bfd interval

To set the Bidirectional Forwarding Detection (BFD) intervals for this interface, use the bfd interval
command. To restore the system to its default condition, use the no form of this command.
Syntax Description
milliseconds
min_rx
multiplier
interval-multiplier
Defaults Interval milliseconds-50
Min_rx_50
Multiplier interval-multiplier-3
Command Modes
Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples
This example shows how to set the BFD intervals:
switch# configure terminal
switch# configure terminal
switch(config)# interface ethernet 2/2
switch(config-if)# bfd interval 100 min_rx 100 multiplier 4
OL-24994-01
bfd interval milliseconds min_rx milliseconds multiplier interval-multiplier
no bfd interval
TX interval in milliseconds, which is the required rate at which control
packets can be received. The range is from 50 to 999 milliseconds.
Specifies minimum RX interval, which is the desired rate for transmitting
control packets. The range is from 50 to 999 milliseconds.
Specifies the detect multiplier for BFD sessions.
Multiplier interval. The range is from 1 to 50 milliseconds.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
bfd interval
117