Sony HANDYCAM DCR-PC106E Operation Manual page 71

4
Touch (pause) again at the point
where you want to start recording the
sound.
The playback pauses.
5
Touch and select [PAGE3].
6
Touch [A DUB CTRL].
60min 0:00:00:00
A DUB CTRL
RET.
AUDIO
DUB
7
Touch [AUDIO DUB].
X mark appears on the LCD
A green
screen.
60min 60min 0:00:00:00 0:00:00:00
A DUB CTRL
RET.
AUDIO
DUB
8
Touch (play) and start playing
back the audio you want to record at
the same time.
A red mark remains on the LCD screen
while recording sound.
The new sound is recorded in stereo 2
([ST2]) during the playback of the tape.
9
Touch (stop) when you want to
stop recording.
To dub on other scenes, repeat steps 3 and 4
to select scenes, then touch [AUDIO DUB].
10
Touch [ RET.], then
To set the end point for audio dubbing
During playback, press ZERO SET MEMORY
on the Remote Commander at the scene at
which you want to stop audio dubbing. Then,
perform steps 4 to 8. The recording stops
automatically at the selected scene.
b Note
• You can only record additional audio over a tape
recorded on your camcorder. The sound may
deteriorate when you dub audio on a tape recorded
on other camcorders (including other DCR-PC106E/
PC107E camcorders).
Checking and adjusting the
recorded sound
1
Play back the tape on which you have
recorded audio in "Recording sound"
(p. 70).
2
Touch
3
Touch MENU.
4
Select
PC106E, or
PC107E, then select [AUDIO MIX]
with
5
Touch
balance between the original sound
([ST1]) and the sound added
afterwards ([ST2]). Then, touch
[EXEC].
The original sound ([ST1]) is output in the
default setting.
.
The adjusted audio balance returns to the
default setting in about 5 minutes after the
battery pack or other power sources have
been disconnected.
to display [PAGE1].
(PLAYER SET) for DCR-
(VCR SET) for DCR-
/ , then touch [EXEC].
VCR SET
HiFi SOUND
AUDIO MIX
ST1 ST2
EXEC RET.
/ to adjust the
Dubbing/Editing
71