Sony HANDYCAM DCR-PC106E Operation Manual page 13

6
Insert your camcorder into the
Handycam Station.
7
Set the POWER switch to OFF (CHG).
The CHARGE lamp lights up and charging
starts.
To charge the battery pack using only
the AC Adaptor
DC IN jack
Mains lead
To the wall socket
DC plug
AC Adaptor
You can charge the battery pack on a trip, even
if you have not brought the Handycam Station
along. With the v mark on the DC plug facing
front, connect the AC Adaptor to the DC IN jack
on your camcorder as shown in the illustration.
After charging the battery
The CHARGE lamp turns off when the battery
is fully charged. Disconnect the AC Adaptor
from the DC IN jack.
To remove the battery pack
Battery pack
POWER switch
1
Set the POWER switch to OFF (CHG).
2
Slide the BATT
lever in the direction of the arrow as
shown in the illustration and remove the
battery pack.
b Note
• Always attach the terminal cover to protect the
battery terminal. If you do not use the battery pack
for a long time, use up the battery pack completely
before storing it. See page 86 about storage of the
battery pack.
BATT
(battery release)
lever
(battery release)
,continued
13
Getting started