Technical Data - Quart Healthcare Topaz 8 Plus User Manual

The Control Unit is on but
the mattress is not
alternating
Service (Malfunction) Alarm
is on
The Control Unit is noisy
Patient is bottoming out
(without alarm triggered)
If the above information does not solve the problem, please contact your local dealer or agent for further support.

11. TECHNICAL DATA

11.1 Product Specification
CONTROL UNITUNIT
DIMENSION(cm)
WEIGHT(kg)
CYCLE TIME
STATIC TIME
AUTO FIRM TIME
CONTROL UNIT
OUTPUT FLOW
RANGE (Liter)
CONTROL UNIT
OUTPUT PRESSURE
RANGE (mmHg)
POWER
CURRENT
FUSE RATING
FREQUENCY
CLASSIFICATION
WARRANTY

If all of above steps have been checked. Press "Alarm Mute" for
system to be verified again.

Ensure the mattress has completely inflated.

Check the control panel, the indicator light for "Alternate" should
be on, if not, switch it to "Alternate."

Check if "Service" alarm indicator is on with buzzer, if yes, contact
the dealer.

Press "alarm mute" for system to be verified again. If the alarm is
still on, please contact dealer or agent.

Make sure the Control Unit is resting against a solid surface.

If the noise is getting louder, contact your dealer for further
investigation.

Pressure settings might be inadequate for the patient, adjust
comfort level to FIRM (refer to Table 1 Weight and Comfort Level
Reference Table) and wait for a few minutes for better comfort.

Follow the procedures "The low pressure light is constantly flashing
and the alarm has sounded" for inspection.
33 (W) x 24 (D) x13 (H)
3.5
10/15/20/25/30minutes
20 minutes
20 minutes
> 8L (120V)
Note: The flow rate may be
varied because of the
fluctuation of input voltage
15 to 50 (±5)
AC120 V 60Hz
0.25A (@132V~)
MAX
T1A 250VAC
60 Hz (120V)
Class II
Type BF
1 year
AIR MATTRESS
DIMENSION(cm)
WEIGHT(kg)
CELL MATERIAL
NO. OF AIR CELL
COVER MATERIAL Two way stretch polyester
BOTTOM
MATERIAL
MAX WEIGHT
WARRANTY
16
200 (L) x 90 (W) x 20 (H)
9
TPU
18 Cells
Polyester-PU
350 lbs
1 year