Quart Healthcare Topaz 8 Plus User Manual page 11

Pressing both the Soft and Firm buttons together will activate Auto-Detection
and Auto-Detection will automatically set the appropriate pressure output for
the patient. When activated, the Auto-Detection light will flash to indicate the
Control Unit is detecting the comfort level for the individual. Once the Control
Unit has completed detecting, the Auto-Detection light will stop flashing and
remain ON. The mattress pressure can be manually adjusted by pressing Soft or
Firm button if the individual wishes to change the comfort level.
5.2 OPERATION GUIDE
5.2.1 General Operation:
NOTE:
 Press
up accompanied with a beep for 2 seconds (check for indicator failure if any),
and the Standby indicator on the control panel will light up. If the Control Unit
was previously shut off in operate mode then the Control Unit will enter
operate mode directly.
P.S. To test the alarm battery, press
failure alarm should be triggered. Refer to 5.2.3 Audiovisual Alarm if the
alarm is not triggered.
 Press the Operate button
"Auto-Firm" indicator will be flashing.
 The mattress should be fully inflated within 60 minutes, and automatically
enter the previous operating mode, otherwise the low pressure alarm with
warning code "
Note: Do not proceed to other settings before inflation is completed.
 After initial inflation is completed. Press Auto-Firm button
person onto the mattress. The mattress will turn into a static condition in
around 5 minutes. Move the patient onto the mattress and press Auto-Firm
button
 According to the weight of the patient, adjust the pressure setting to the most
suitable level without "bottoming-out". User can determine an appropriate
pressure by adjusting the Comfort Level. Please consult with your physician for
a proper setting.
The power switch is located on the side of the Pump.
to turn on the unit, all LED indicators on the control panel will light
" will be triggered.
again to cancel Auto-Firm mode and select the appropriate mode.
to turn off the power and the power
and the system will begin to inflate and the
10
to transfer