Cleaning - Quart Healthcare Topaz 8 Plus User Manual

10
11
12
13
14
15
16

6. CLEANING

Wipe the Control Unit with a damp cloth pre-soaked with a mild detergent, and
keep the Control Unit away from dust. If other detergent is used, choose one that
will have no chemical effects on the surface of the plastics case of the Control Unit.
CAUTION: Do not immerse or soak the Control Unit.
Clean the mattress cover by using single use wipes with a solution of neutral
detergent and hand hot water. Rinse thoroughly with clean water and damp dry
the mattress using single use wipes.
Disinfecting the cover
If the cover is heavily soiled or has been exposed to bodily fluids such as blood, it
will require a more thorough cleaning procedure.
Use single use wipes with a 0.1% chlorine solution (1,000ppm) and cold water to
wipe the cover. Rinse thoroughly with clean water and damp dry the mattress using
single use wipes. Ensure the cover is completely dried before placing on the
mattress.
Frequent or prolonged exposure to higher concentration disinfectant solutions may
prematurely age the fabric cover of mattresses. Cover surfaces should be protected
during use and rinsed and dried thoroughly after disinfectant.
(Cycle 4 sec.)
REPEAT
Low Pressure
(Cycle 4 sec.)
REPEAT
Service (Cycle 4.5
sec.)
REPEAT
Service (Cycle 4.5
sec.)
REPEAT
Service (Cycle 4.5
sec.)
REPEAT
Service (Cycle 15
sec.)
NONE NONE
NONE NONE
STANDBY
OPERATE OR Low Pressure Overtime
STANDBY Alarm
OPERATE OR High Pressure Overtime
STANDBY Alarm
OPERATE OR High Ambient
STANDBY Temperature Alarm
OPERATE OR Air Valve 1 Positioning
STANDBY Failure Alarm
OPERATE OR
Battery Low Alarm
STANDBY
FACTORY
Calibration Not
CALIBRATION
Completed
MODE
FACTORY
CALIBRATION Calibration Completed
MODE
13
Low Pressure
High Pressure
High Temperature
Air Valve 1 failure
Battery would need to be
replaced
Calibration Unfinished
Calibration Completed