Storage; Maintenance - Quart Healthcare Topaz 8 Plus User Manual

Laundering



Drying
Mattress covers should be hung from a line or bar and drip dried in a clean indoor
environment. Covers must be completely dried before returning to the mattress.
Mattress covers can be tumble dried on a low heat setting for 90 minutes. Drying
temperature must not exceed 40°C. Exceeding the temperature can cause
significant damage to the mattress cover.
CAUTION: Do not use phenolic-based product for cleaning.
CAUTION: After cleaning, dry the mattress without direct exposure of sunlight.

7. STORAGE

 To quickly vacuum air out from mattress for storage, rotate the CPR valve to OPEN
position and disconnect the hose connector to release the air.
 Lay the mattress out flat and upsides down.
 Roll from the head end towards the foot end.
 Packing strap can then be stretched around the rolled mattress to prevent
unrolling.
 The power cord could be wrapped around the Control Unit bumper or
disconnected for storage.

8. MAINTENANCE

General
 Check main power cord and plug for any abrasions or excessive wear.
 Check mattress cover for signs of wear or damage. Ensure mattress cover and
tubes are stubbed together correctly.
 Check the air hoses for any kink or break. For replacement, please contact your
local dealer.
Before laundering, mattress cover should be completely removed.
Mattress covers can be laundered as following:
 Prewash 60℃ +15 minutes
 Main wash 60℃+15 minutes
This should be followed by a cold rinse and extraction.
14