Table of Contents
Advertisement
Installing the Canopy
1. If your machine is equipped with a rollover prtection
system (ROPS), you do not need to install a rear
support tube; proceed to step 3. If your machine is not
equipped with a ROPS, proceed as follows to install
the rear support tube:
Note: Machines with a ROPS does not use the parts
described in the following sub-steps.
A. Loosely install the support brackets to the rear
support tube using 4 bolts (5/16 x 2-3/4 inches),
4 bolts (5/16 x 1-3/4 inches), 4 flat washers (5/16
inch), and 8 flange nuts (5/16 inch) as shown in
Figure
2.
Left side shown
1. Rear support tube
2. Left-side rear support
bracket
3. Flat washer (5/16 inch)
Figure 2
4. Bolt (5/16 x 2-3/4 inches)
5. Bolt (5/16 x 1-3/4 inches)
6. Flange nut (5/16 inch)
B. Loosely install the rear tube and support-bracket
assemblies to the machine using 8 bolts (5/16 x
1 inch) and 8 flange nuts (5/16 inch) as shown
in
Figure
5
g009307
1. Left, front support
2. Rear support tube
(assembled)
3. Flange nut (5/16 inch)
2. Install the left, front support tube to the machine as
shown in
Figure
4
3.
6
1
3
Figure 3
Left side shown
4. Bolt (5/16 x 1 inch)
5. Flange nut (5/16 inch)—for
the left side it is existing;
for the right side it is a
loose part
6. Carriage bolt (5/16 x 3/4
inch)
3.
4
2
4
G009288
g009288
Advertisement
Table of Contents
